User’s Guide
for the
CRATE PRO AUDIO
SM5-HP
Five Channel Headphone Amplifier
Download from Www.Somanuals.com. All Manuals Search And Download.
SM5-HP Five Channel Headphone Amplifier
Table of Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
A Description of the SM5-HP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
The Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
The Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Connecting the AC Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Applications
Connecting to a Stereo Headphone Jack . . . . . . . . . . . . . . . . . . .6
Connecting to the Stereo Outputs of a Recorder . . . . . . . . . . . . .6
Connecting to a Mono Monitor Jack . . . . . . . . . . . . . . . . . . . . . .7
Technical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . .back cover
ATTENTION
RISQUE D'ELECTROCUTION
NE PAS OUVRIR
VORSICHT
ELEKTRISCHE SCHLAGGEFAHR
NICHT OFFENEN
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION: POUR REDUIRE D'ELECTRO-
CUTION NE PAS
VORSICHT: ZUR MINIMIERUNG ELEK-
TRISCHER SCHLAGGEFAHR NICHT
DEN DECKEL ABENHMEN. INTERNE TEILE
KONNEN NICHT VOM
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER.
ENLEVER LE COUVERCLE. AUCUNE PIECE
INTERNE N'EST REPRABLE
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
PAR L'UTILISATEUR. POUR TOUTE REPA-
RATION, S'ADRESSER A UN
BENUTZER GEWARTET WERDEN. DIE
WARTUNG IS QUALIFIZIERTEM
TECHNICIEN QUALIFIE.
WARTUNGSPERSONAL ZU UBERLASSEN.
THIS EQUIPMENT HAS BEEN DESIGNED AND ENGINEERED TO PROVIDE SAFE AND RELIABLE OPERATION. IN ORDER TO PROLONG THE LIFE
OF THE UNIT AND PREVENT ACCIDENTAL DAMAGES OR INJURY, PLEASE FOLLOW THESE PRECAUTIONARY GUIDELINES:
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT OPEN CHASSIS.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
WARNING: AVOID PROLONGED EXPOSURE OF THE EQUIPMENT TO EXTREME HEAT.
CAUTION: NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
EXPLANATION OF GRAPHICAL SYMBOLS:
"DANGEROUS VOLTAGE"
"DANGER HAUTE TENSION"
"GEFAHLICHE SPANNUNG"
"IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL"
"REFERREZ-VOUS AU MANUAL D'UTILISATION"
"UNBEDINGT IN DER BEDIENUNGSANLEITUNG NACHSCHLAGEN"
=
=
Download from Www.Somanuals.com. All Manuals Search And Download.
SM5-HP Five Channel Headphone Amplifier
Introduction:
Thank you for selecting the Crate SM5-HP five channel headphones amplifier. This
compact device has been designed with the audio professional in mind, providing
accuracy, quality, ease of use and straight-forward design. Manufactured in the United
States, using only the finest componenets, the SM5-HP takes up only one-third of a sin-
gle rack space!
In order to achieve maximum performance from your SM5-HP and to better under-
stand its applications, please read this user’s guide prior to its use.
And “Thank You” from
A Description of the SM5-HP:
The SM5-HP allows you to distribute a single source – the headphones output of a
mixer, the line outs of a recorder, the monitor output of a sound board, etc. – to up to
five separate pairs of stereo headphones, each with its independent level control, with-
out degradation of signal quality or interference between phones.
HEAD
PHONES
TO
INPUT
3
Download from Www.Somanuals.com. All Manuals Search And Download.
SM5-HP Five Channel Headphone Amplifier
The Front Panel:
1 2
1. Headphone Output Jack: Each channel of the SM5-HP has a stereo (T/R/S) 1/4” jack for con-
necting to a pair of stereo headphones. The signal level at each jack is determined by the setting
of that channel’s output level control (#2), as well as the level of the input signal.
2. Output Level Control: Each channel of the SM5-HP has its own output level control. Each
channel operates independently from the others – an adjustment to the level on one channel will
not alter the level of any of the other channels. Please see “Muting Feature Note” on page 5.
The Rear Panel:
LEFT
RIGHT
(STEREO)
(MONO)
9-10 VAC
50-60 Hz
500mA MINIMUM
3
4
5
6
3. Power Supply Jack: Plug the small metal barrel connector of the AC power adapter here.
4. Cord Cinch: Use this clip to secure the cable of the power pack to the chassis of the SM5-HP.
5. Left (Stereo) Jack: This stereo (T/R/S) 1/4” jack feeds a stereo signal (such as from a
Headphones Output jack) or the left channel of a stereo signal (such as from a tape deck line out)
into the SM5-HP (see page 6).
6. Right (Mono) Jack: This mono (T/S) 1/4” jack feeds a mono signal (such as from a Monitor
Output jack) or the right channel of a stereo signal (such as from a tape deck line out) into the
SM5-HP (See page 6, 7).
4
Download from Www.Somanuals.com. All Manuals Search And Download.
SM5-HP Five Channel Headphone Amplifier
Connecting the AC Power Supply:
A
LEFT
RIGHT
(MONO)
C
(STEREO)
9-10 VAC
50-60 Hz
500mA MINIMUM
9-10 VAC
50-60 Hz
500mA MINIMUM
B
A) Slide the power adapter cable into the cord cinch as shown above, leaving a few inches
of cable between the cinch and the cable’s small metal barrel connector.
B) Plug the barrel connector into the power supply jack.
C) After all other connections are made, plug the power pack into a suitable source of AC
line voltage. (See the sticker on the power adapter for voltage requirements.)
NOTE: Since the SM5-HP is “always on” when the power pack is plugged in to a
live outlet, it is advised that you unplug the power pack (or turn off the AC source)
when not using the unit for extended time periods.
Muting Feature Note: The SM5-HP incorporates a muting circuit which can
silence an output jack whenever its level control is at or very near the fully
counter clockwise position. A soft “click” will be heard through the headphones
when the muting circuit is engaged.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
SM5-HP Five Channel Headphone Amplifier
Applications:
Connecting to a
Stereo Headphone Jack
T
H
G
I
R
(MONO
LEFT
T
F
(STEREO)
E
L
(STERE
Connect the
Headphones output
jack of a mixing board
(or other source) to the
Left/Stereo jack of the
SM5-HP using a
shielded stereo (T/R/S)
1/4” signal cable.
HEADPHONES
Applications:
Connecting to the Stereo
Outputs of a Recorder
T
RIGHT
H )
G O
I
N
R O
M
(
Connect the left and
right Line Out jacks of
a recorder (or other
source) to the Left and
Right jacks of the
SM5-HP using shield-
ed RCA cables and
RCA-to-1/4” (mono)
adapters.
LEFT
T
T
F
)
E EO
LER
S
(
R
LINLE OUT
6
Download from Www.Somanuals.com. All Manuals Search And Download.
SM5-HP Five Channel Headphone Amplifier
Applications:
Connecting to a
Mono Monitor Jack:
RIGHT
(MONO)
)
O
N
RIOGHT
(M
Connect the Monitor
output jack of a mix-
ing board (or other
source) to the
)
LEFT
(STERE
Right/Mono jack of
the SM5-HP using a
shielded mono (T/S)
1/4” signal cable. The
signal at the head-
phones will be mono,
with the same signal
on both sides of the
phones.
MONITOR OUT
7
Download from Www.Somanuals.com. All Manuals Search And Download.
SM5-HP Five Channel Headphone Amplifier
Technical Specifications:
Power Output, 1–5 channels driven
32 ohms 570mW
50 ohms 400mW
100 ohms 200mW
200 ohms 100mW
300 ohms 67mW
600 ohms 34mW
Maximum Gain
12dB
Frequency Response
THD + Noise
8Hz – 50kHz
.09% @ 200 ohms (100mW)
Signal to Noise Ratio
Power Supply Requirements
Size and Weight
-90dB @ 200 ohms (100mW, 1kHz)
9–10VAC, 500mA
1.6” H x 5.6” W x 5.5” D; 1.5 lbs (without power adapter)
Specifications subject to change without notice.
©1999 SLM Electronics, Inc. • A Division of St. Louis Music, Inc.
1400 Ferguson Avenue • St. Louis, MO 63133
47-839-05 • 01/99
Download from Www.Somanuals.com. All Manuals Search And Download.
|