Crate Amplifiers Stereo Amplifier GLX50 User Manual

GLX50  
Dual Input Guitar Amplifier  
with  
Digital Signal Processing  
User’s Guide  
Download from Www.Somanuals.com. All Manuals Search And Download.  
GLX50 Guitar Amplifier with Digital Signal Processing  
TABLE OF CONTENTS:  
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3  
The Digital Signal Processor . . . . . . . . . . . . . . . . . . . . .3  
The Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4,5  
Suggested Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . .6  
System Block Diagram . . . . . . . . . . . . . . . . . . . . . . . . .7  
Technical Specifications . . . . . . . . . . . . . . . . .back cover  
CAUTION  
PRECAUCION  
ATTENTION  
RISK OF ELECTRIC SHOCK  
DO NOT OPEN  
RIESGO DE CORRIENTAZO  
NO ABRA  
RISQUE D'ELECTROCUTION  
NE PAS OUVRIR  
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC  
SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOIS-  
TURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT  
REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE.  
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.  
ADVERTENCIA: REDUCIR EL RIESGO DE FUEGO O CHOQUE ELÉCTRI-  
CO, NO LE EXPONE DE ESTE APARATO A LLUVIA O HUMEDAD. PARA  
DISMINUOIR EL RIESGO DE CORRIENTAZO. NO ABRA LA CUBIERTA.  
NO HAY PIEZAS ADENTRO QUE EL USARIO PUEDO REPARAR DEJE  
TODO MANTENIMIENTO A LOS TECHNICOS CALIFICADOS.  
ATTENTION: POUR REDUIRE D'ELECTROCUTION NE PAS  
ENLEVER LE COUVERCLE. AUCUNE PIECE INTERNE N'EST  
REPRABLE PAR L'UTILISATEUR. POUR TOUTE REPARATION,  
S'ADRESSER A UN TECHNICIEN QUALIFIE.  
IMPORTANT SAFETY INSTRUCTIONS  
READ, FOLLOW, HEED, AND KEEP ALL INSTRUCTIONS AND WARNINGS.  
DO NOT OPERATE NEAR ANY HEAT SOURCE AND DO NOT BLOCK ANY VENTILATION OPENINGS ON THIS APPARATUS.  
DO NOT USE THIS APPARATUS NEAR SPLASHING, FALLING, SPRAYING, OR STANDING LIQUIDS.  
CLEAN ONLY WITH LINT-FREE DAMP CLOTH AND DO NOT USE CLEANING AGENTS.  
ONLY CONNECT POWER CORD TO A POLARIZED, SAFETY GROUNDED OUTLET WIRED TO CURRENT ELECTRICAL CODES AND  
COMPATIBLE WITH VOLTAGE, POWER, AND FREQUENCY REQUIREMENTS STATED ON THE REAR PANEL OF THE APPARATUS.  
PROTECT THE POWER CORD FROM DAMAGE DUE TO BEING WALKED ON, PINCHED, OR STRAINED.  
UNPLUG THE APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME.  
ONLY USE ATTACHMENTS, ACCESSORIES, STANDS, OR BRACKETS SPECIFIED BY THE MANUFACTURER FOR SAFE OPERA-  
TION AND TO AVOID INJURY.  
THIS APPARATUS DOES NOT OPERATE NORMALLY AND REQUIRES SERVICE WITH ANY PHYSICAL DAMAGE FROM IMPACT OR  
ANY EXPOSURE TO MOISTURE.  
SERVICE MUST BE PERFORMED BY QUALIFIED PERSONNEL.  
OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND  
PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PRO-  
TECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME.  
EXPLANATION OF GRAPHICAL SYMBOLS:  
EXPLICACION DE SIMBOLOS GRAFICOS:  
EXPLICATION DES SYMBÔLES GRAPHIQUES:  
"IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL"  
“ES NECESARIO QUE EL USUARIO SE REFIERA AL MANUAL DE INSTRUCCIONES.”  
"REFERREZ-VOUS AU MANUAL D'UTILISATION"  
"DANGEROUS VOLTAGE"  
“VOLTAJE PELIGROSO”  
"DANGER HAUTE TENSION"  
=
=
Download from Www.Somanuals.com. All Manuals Search And Download.  
GLX50 Guitar Amplifier with Digital Signal Processing  
Congratulations!  
You are now the proud owner of the Crate GLX50 guitar amplifier. This unique amplifier  
allows two players to play simultaneously, making it perfect for students, band practices,  
and live performances. An easy to operate DSP section lets you dial in a variety of digital  
effects such as delay, flange, chorus and reverb. RCA inputs with a level control allow you  
to play along with a compact disc, a tape, or a drum machine. The active electronic tuner  
allows for perfect tuning and is switchable for use on either of the two channels.  
Like all Crate products, your GLX50 amplifier is designed by musicians, and built using only  
the best components. Extensive testing confirms that this amplifier is the absolute best it can be.  
In order to get the most out of your new amplifier, we strongly urge you to read the infor-  
mation contained in this manual before you begin playing.  
And thank you for choosing  
The Digital Signal Processor:  
Crate’s Digital Signal Processing offers eight exciting digital effects, accessible through the  
DSP Mode control. The effects are described below.  
1
Bypass - no effect  
2
3
4
5
6
7
8
9
Delay 1 - short delay effect  
Delay 2 - long delay effect  
Flange - light flanging effect  
Chorus 1 - slow chorus effect  
Chorus 2 - fast chorus effect  
Chorus + Reverb - slow chorus with reverberation  
Reverb 1 - small room reverberation  
Reverb 2 - large hall reverberation  
Use the Mode control to select the effect and the Level control to mix in the desired amount of  
each effect.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
GLX50 Guitar Amplifier with Digital Signal Processing  
The Front Panel:  
1
2
3
4
5
6
7
8
9
10  
NOTE: Channel A and Channel B are independent of each other up to the DSP and CD inputs.  
The text below (#1–10) applies to both channels.  
1. INPUT: Use this 1/4” jack to connect your guitar to the amplifier by means of a shielded instru-  
ment cable.  
2. TUNER A / TUNER B: Use this switch to assign the electronic tuner (#16) to Channel A (switch  
in the out position) or Channel B (switch depressed).  
3. CLEAN: Use this control to adjust the output level of the Clean channel.  
4. CLEAN / OVERDRIVE: Use this switch to select the Clean channel (switch in the out position) or  
the Overdrive channel (switch depressed).  
5. OD GAIN: Use this control to adjust the Overdrive channel’s input signal gain. This control works  
in conjuntion with the OD Level control (#9) to set the amount of distortion and the output signal level  
of the Overdrive channel.  
6. HIGH: Use this control to adjust the high frequency level of the output signal. This control has a  
range of 27dB of boost or cut at 12kHz.  
7. MID: Use this control to adjust the midrange frequency level of the output signal. This control has  
a range of 20dB of boost or cut at 1.5kHz.  
8. LOW: Use this control to adjust the low frequency level of the output signal. This control has a  
range of 28dB of boost or cut at 40Hz.  
9. OD LEVEL: Use this control to adjust the Overdrive channel’s output signal level. This control  
works in conjunction with the OD Gain control (#5).  
10. EFFECTS: Use this control to adjust the amount of digital effects applied to the output signal.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
GLX50 Guitar Amplifier with Digital Signal Processing  
11  
12  
13  
14  
15  
16 17  
18  
11. DSP MODE: Use this control to select one of the eight built-in digital effects. A listing of the effects is  
printed below the control knob. A brief description of these effects is shown on page 3 of this manual.  
12: DSP LEVEL: Use this control to adjust the output level of the digital effect: in its fully counter-  
clockwise position the signal will be “dry” (without any effect). As you rotate the control clockwise the  
amount of effect increases.  
13. CD INPUT LEVEL: Use this control to adjust the input level of the signal from the CD Input jacks  
(#14).  
14. CD INPUT JACKS: Use these jacks to connect the output of a CD player, tape deck or drum  
machine to the amplifier. The jacks are internally summed to create a mono signal.  
15. HEADPHONES: Use these jacks to connect one or two pairs of stereo headphones to the ampli-  
fier. Each Headphones jack monitors the signal from both Channel A and Channel B. The internal  
speaker is disconnected when the Headphone jacks are used.  
16. ELECTRONIC TUNER: The electronic tuner is active whenever the amplifier is turned on, pro-  
viding constant, “real-time” tuning. The bottom row of LEDs indicate which note (string) is being  
tuned. The top row of LEDs provides directional queues to facilitate quick and precise tuning of your  
instrument. The indicated note (string) is properly tuned when only the center LED is illuminated.  
17. LED: This LED illuminates when the amplifier is on.  
18: POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of  
the switch depressed).  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
GLX50 Guitar Amplifier with Digital Signal Processing  
Suggested Settings:  
CRYSTAL CLEAN:  
PUNCHY CLEAN:  
DIRTY PUNCH:  
DIRTY BLUES:  
EDGIE:  
OUT  
OUT  
IN  
IN  
IN  
SWEATY METAL:  
ARENA METAL:  
MAMMOTH METAL:  
IN  
IN  
IN  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
GLX50 Guitar Amplifier with Digital Signal Processing  
System Block Diagram:  
CHANNEL A:  
INPUT  
OD  
GAIN  
OD  
LEVEL  
EFFECTS  
LEVEL  
HIGH MID LOW  
CLEAN  
OVER-  
DRIVE  
TUNER  
BC EF  
DSP  
A
D
G
LEVEL  
MODE  
CHANNEL B:  
INPUT  
OD  
GAIN  
OD  
LEVEL  
EFFECTS  
LEVEL  
HIGH MID LOW  
CLEAN  
OVER-  
DRIVE  
POWER  
AMP  
SPEAKER  
MIX  
STAGE  
CD  
INPUTS  
HEAD  
PHONES  
LEVEL  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
GLX50 Guitar Amplifier with Digital Signal Processing  
GLX50 TECHNICAL SPECIFICATIONS:  
Output Power Rating  
50 watts RMS @5% THD, 4 ohm load  
5 volts peak-to-peak  
Maximum Input Signal Accepted  
Total System Gain  
Clean Channel  
70dB, all controls @10  
110dB, all controls @10  
Overdrive Channel  
Input Impedance  
Tone Controls  
270k ohm  
Low  
Mid  
28dB range @ 40Hz  
20dB range @ 1.5kHz  
27dB range @ 12kHz  
High  
CD Inputs  
Maximum signal level 7.75V rms  
Minimum impedance 32 ohms  
Headphones  
Internal Speaker  
12” Crate Custom, 4 ohms, 1.5” voice coil,  
30 oz. magnet  
Input Power Requirements  
Size and Weight  
120 VAC, 60Hz, 75VA  
100/115VAC, 50/60Hz, 75VA  
230VAC, 50/60Hz, 75VA  
19” H x 19-3/8” W x 9-1/2” D, 28 lbs.  
The GLX50 is covered with a durable Tolex material: wipe it clean with a lint-free cloth.  
Never spray cleaning agents onto the cabinet. Avoid abrasive cleansers which would damage the finish.  
Crate continually develops new products, as well as improves existing ones. For this reason, the specifications  
and information in this manual are subject to change without notice.  
Declaration Of Conformity  
#33, Effective 01-01-2001  
Manufacturers Name:  
Production Facility:  
SLM Electronics  
11880 Borman Drive, St. Louis, MO 63146, USA  
700 Hwy 202 W, Yellville, AR 72687, USA  
1400 Ferguson Ave., St. Louis, MO 63133, USA  
1400 Ferguson Ave., St. Louis, MO 63133, USA  
Production Facility:  
Shipping Facility:  
Office Facility:  
Product Type:  
Audio Amplifier  
Complies with Standards:  
LVD:  
Safety:  
EMC:  
92/31/EEC, 93/68/EEC, & 73/23/EWG  
EN60065  
EN55013, EN55020, EN55022, EN61000-3-2,  
& EN61000-3-3  
Supplementary information provided by:  
SLM Electronics - R & D Engineering  
1901 Congressional Drive, St Louis, MO 63146, USA  
Tel.: 314-569-0141, Fax: 314-569-0175  
@2002 SLM Electronics, a division of St. Louis Music, Inc 1400 Ferguson Avenue St. Louis, MO 63133  
47-383-01 110402  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Crate Amplifiers Stereo Amplifier TX50DE User Manual
Crate Amplifiers Stereo Amplifier BFX 220H User Manual
Crate Amplifiers Portable Speaker PSM6P User Manual
Crate Amplifiers Musical Instrument Amplifier MX65R User Manual
Crate Amplifiers Musical Instrument Amplifier GLX30 User Manual